PanelMate Series

Downloadable AT PanelMate Catalog  |  Downloadable ATP PanelMate Catalog

2, 3, 4, 6, 8 and 12 Position / Size 16, 13A

13 Position / Size 12, 25A; Size 16, 13A

The Amphenol Panel|Mate™ series combines flange mounting options with the proven reliability of the AT/ATP Series™ environmentally-sealed thermoplastic connection system. Engineered with a one-piece sealed flange design for rapid and secure mounting, its durable high temperature silicone facial seal provides a barrier of protection from lubricating oils, hydraulic fluids and fossil fuels to withstand the challenges and complexities of harsh environment applications.

Wire RangeSize 12 contacts will accept wire ranges of 12-14AWG; Size 16 contacts will accept 14-20AWG.
TemperatureOperating temperature range: -55°C to +125°C at rated current
Housing/LatchThermoplastic/Integrated latch for mating
Dielectric ValueMeets or exceeds 1500 volts minimum
Drop Test Shall not become detached or loosened when placed at 750mm and dropped to concrete eight times
Shock No latch disengagement or discontinuity shall be the result when subjected to 50 g’s in each of three axis (X, Y & Z)
VibrationContinued continuity without degradation to mechanical or physical attributes following vibration. (max acceleration 20 g’s at Sine sweep of 10-2000Hz)
Connector Terminal RetentionWhen subjected to a direct pull, contacts achieve a minimum pull-out force of 25 lbs.
Connector RetentionA mated connector subjected to a pulling force by the exiting wire bundle at 25 lbs. times the number of contacts to a maximum of 100 lbs. applying load for 30 seconds
Thermal ShockSubjected to 10 cycles at -55°C to +125°C with no cracking, chipping or other damage detrimental to the normal operation of the connector
Insulation Resistance1000 megohms minimum at 25°C
Mating Cycle Durability Following 100 cycles of connection engagement and disengagement, degradation either mechanical or electrical is not evident
Contact Millivolt DropSize 16 contacts with 16AWG conductor - 100 mV drop max at 13A test current
Water ImmersionA mated connection, properly wired, placed in an oven at +125°C for 1 hour, then placed immediately in a depth of water of 1 meter without loss of electronic performance

For more information, contact:
Don Hunsucker, Product Manager, +1 586 913 8638, [email protected]